0
RESEARCH PAPERS

Boundary Layer and Loss Measurements on the Rotor of an Axial-Flow Turbine

[+] Author and Article Information
H. P. Hodson

Whittle Laboratory, University of Cambridge, Cambridge, England CB3 005

J. Eng. Gas Turbines Power 106(2), 391-399 (Apr 01, 1984) (9 pages) doi:10.1115/1.3239576 History: Received November 24, 1982; Online October 15, 2009

Abstract

The aerodynamic efficiency of an axial-flow turbine is significantly less than that predicted by measurements made on equivalent cascades which operate with steady inflow. This difference in efficiencies is strongly dependent upon the rotor-stator axial spacing. An experimental investigation of the rotor-stator interaction has therefore been conducted using a large-scale, low-speed turbine. The blade profile loss and surface shear stresses are presented for the midspan of the rotor and for a rectilinear cascade of identical geometry. Both wind tunnels were operated at a Reynolds number of 3.15 × 105 . The turbine rotor midspan profile loss was approximately 50 percent higher than that of the rectilinear cascade. The shear stress measurements indicate that as a stator wake is connected through a rotor passage, the laminar boundary layers undergo transition in the vicinity of the wake. The 50 percent increase in loss is due to the time-dependent transitional nature of the boundary layers.

Copyright © 1984 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In