0
RESEARCH PAPERS

Progress on the Investigation of Coal-Water Slurry Fuel Combustion in a Medium Speed Diesel Engine: Part 2—Preliminary Full Load Test

[+] Author and Article Information
B. D. Hsu

Transportation Systems, General Electric Company, Erie, PA 16531

J. Eng. Gas Turbines Power 110(3), 423-430 (Jul 01, 1988) (8 pages) doi:10.1115/1.3240138 History: Received July 21, 1987; Online October 15, 2009

Abstract

Full load (186 kW/cyl) operation using CWS fuel at 1050 rpm has been achieved on a single-cylinder GE-7FDL test engine. No major changes in engine parameters were made. With normal inlet air conditions, 3–5 percent pilot diesel fuel, separately injected or stratified into the main coal charge, was used. Inlet air temperature had to be raised about 40°C if no pilot diesel fuel was used. The coal burnout was about 95 percent and the cycle efficiency was comparable to using diesel fuel. The NOx and CO emissions were about 1/2 of those obtained normally with diesel fuel. The maximum heat release rate was higher than diesel fuel operation which resulted in higher maximum cylinder firing pressure. The combustion characteristic and its dependence on some fuel characteristics and inlet air parameters are discussed. Increasing coal burnout while limiting maximum cylinder firing pressure is the main objective of near future studies.

Copyright © 1988 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In