Design for the 145-MW Blast Furnace Gas Firing Gas Turbine Combined Cycle Plant

[+] Author and Article Information
H. Takano

Energy Technology Section, Chiba Works, Kawasaki Steel Corporation

Y. Kitauchi

Gas Turbine Designing Section, Takasago Machinery Works, Mitsubishi Heavy Industries, Ltd.

H. Hiura

Engineering Department, Takasago Machinery Works, Mitsubishi Heavy Industries, Ltd.

J. Eng. Gas Turbines Power 111(2), 218-224 (Apr 01, 1989) (7 pages) doi:10.1115/1.3240239 History: Received December 21, 1987; Online October 15, 2009


A 145-MW blast furnace gas firing gas turbine combined cycle plant was designed and installed in a steel works in Japan as a repowering unit. A 124-MW large-scale gas turbine with turbine inlet temperature 1150°C (1423 K) was adopted as a core engine for the combined cycle plant. The fuel of this gas turbine is blast furnace gas mixed with coke oven gas. These are byproducts of steel works, and the calorific value of the mixed gas is controlled to be about 1000 kcal/Nm3 (4187 kJ/Nm3 ). A specially designed multicannular type combustor was developed to burn such a low Btu fuel. The gas turbine, generator, steam turbine, and fuel gas compressor are connected to make a single-shaft configuration. As a result of introducing the gas turbine combined cycle plant, the plant thermal efficiency was above 45 percent (at NET) and the total electricity generation in the works has increased from 243 MW to 317 MW. This paper describes the design features of this combined cycle plant.

Copyright © 1989 by ASME
Your Session has timed out. Please sign back in to continue.





Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In