0
RESEARCH PAPERS

Evaluation of Some Factors Controlling DI Diesel Combustion and Exhaust Emissions

[+] Author and Article Information
C. E. Hunter, H. A. Cikanek, T. P. Gardner

Ford Motor Company, Research Staff, Dearborn, MI 48121

J. Eng. Gas Turbines Power 111(3), 379-386 (Jul 01, 1989) (8 pages) doi:10.1115/1.3240265 History: Received October 01, 1988; Online October 15, 2009

Abstract

The combined effects of turbocharging, high fuel injection pressure, and reduced oil consumption on diesel exhaust emissions were investigated using a single-cylinder research engine. The influence of these exhaust emission control concepts on particulate composition was determined using a new particulate analysis method. In addition, the dependence of particulate composition on engine load and air utilization was examined using the microfumigation technique. Simultaneous application of these emissions control concepts reduced exhaust particulates by 70 percent. High injection pressure reduced the insoluble component of particulates, while reducing oil consumption and turbocharging the engine lowered both soluble and insoluble particulates. Reductions in oil-derived particulates with increasing engine load were partially attributed to increases in volumetric air utilization. Ninety percent of the lube oil found in exhaust particulates was unburned; however, similar concentrations of unburned and partially oxidized components were observed in fuel-derived particulates.

Copyright © 1989 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In