0
RESEARCH PAPERS

Fabrication and Testing of Ceramic Turbine Wheels

[+] Author and Article Information
K. Takatori, T. Honma, N. Kamiya, H. Masaki, S. Wada

Toyota Central R&D Labs., Inc., Nagakute, Aichi, Japan

S. Sasaki

Toyota Motor Corporation, Susono, Shizuoka, Japan

J. Eng. Gas Turbines Power 115(1), 30-35 (Jan 01, 1993) (6 pages) doi:10.1115/1.2906682 History: Received February 20, 1991; Online April 24, 2008

Abstract

A silicon nitride (Si3 N4 ) radial inflow turbine wheel was fabricated by injection molding at Toyota Central R&D Labs. The wheel was 142 mm in outer diameter and had 14 blades. The radial wheel was too bulky to manufacture as a homogeneous and defect-free body in one piece. It was divided into two pieces for injection molding and put together into one body by a cold isostatic pressing step after binder removal. Spin testing was executed at room temperature and the resulting photographs, taken from three directions, provided useful information about the fraction mode of the wheels. The maximum burst speed of the wheels at room temperature was 98,900 rpm, which corresponded to 145 percent of the design speed. In a hot rig test, one of the wheels survived 75,000 rpm for ten minutes at a turbine inlet temperature of 1050°C.

Copyright © 1993 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Related

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In