0
RESEARCH PAPERS

Jet Cooling at the Rim of a Rotating Disk

[+] Author and Article Information
D. E. Metzger, W. J. Mathis, L. D. Grochowsky

Mechanical Engineering Department, Arizona State University, Tempe, Ariz.

J. Eng. Power 101(1), 68-72 (Jan 01, 1979) (5 pages) doi:10.1115/1.3446463 History: Received December 14, 1977; Online July 14, 2010

Abstract

Results are presented from an experimental study conducted to measure heat transfer rates at the rim of a rotating disk convectively cooled by impinging jets. The disk face contour radially inward from the rim is varied to simulate the geometric conditions found on gas turbine engine rotors. Heat transfer rates are found to be relatively unaffected by impingement for jet flowrates less than the order of one-tenth the disk pumping flow. Disk pumping flows are evaluated through the use of an analysis which accounts for the presence of the disk hub. At larger jet flowrates, heat transfer rates increase strongly with increasing jet flow, reaching two to three times the no-impingement values at jet flowrates approximately equal to the pumped flow. All the heat transfer results, both with and without jet impingement, are essentially unaffected by changes in the disk face contour.

Copyright © 1979 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In