0
RESEARCH PAPERS

Measurements of the Boundary Layer Development along a Turbine Blade with Rough Surfaces

[+] Author and Article Information
K. Bammert

Institute for Turbomachinery, University of Hannover, Germany

H. Sandstede

Gutehoffnungshütte Sterkrade AG, Oberhausen, Germany

J. Eng. Power 102(4), 978-983 (Oct 01, 1980) (6 pages) doi:10.1115/1.3230370 History: Received December 10, 1979; Online September 28, 2009

Abstract

During the operation of turbines the surfaces of the blades are roughened by corrosion, erosion and deposits. The generated roughness is usually greater than that produced by manufacture. The quality of the blade surfaces determines the losses of energy conversion in turbine cascades to a great extent. The loss coefficient can be found theoretically by a boundary layer calculation. For rough surfaces there are no boundary layer measurements along the profiles of a turbine cascade. Therefore in a cascade wind tunnel measurements of the boundary layer development were carried out. The chord length of the blades was 175 mm. The cascade represented a section through the stator blades of a 50 percent reaction gas turbine. For smooth surfaces and three different roughnesses up to 3.3 · 10−3 (equivalent sand roughness related to chord length) the boundary layers were measured. The momentum thickness is up to three times as great as that on smooth surfaces. Especially in regions with decelerated flow the effects of roughness are high. A rough surface causes a rise of the friction factor and a shift of the transition of laminar to turbulent flow. The results of the measurements are shown. Correction factors are worked out to get good agreement between measurement and calculation according to the Truckenbrodt theory.

Copyright © 1980 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In