0
TECHNICAL PAPERS: Gas Turbines: Structures and Dynamics

Chebyshev Polynomials Fits for Efficient Analysis of Finite Length Squeeze Film Damped Rotors

[+] Author and Article Information
F. A. Rodrigues, F. Thouverez, C. Gibert, L. Jezequel

Ecole Centrale de Lyon—Laboratoire de Tribologie et Dynamique des Systemes, 36, Avenue Guy de Collongue B. P. 163, 69131 Ecully Cedex, France

J. Eng. Gas Turbines Power 125(1), 175-183 (Dec 27, 2002) (9 pages) doi:10.1115/1.1423319 History: Received March 01, 2000; Revised May 01, 2001; Online December 27, 2002
Copyright © 2003 by ASME
Your Session has timed out. Please sign back in to continue.

References

Chu,  F., and Holmes,  R., 1998, “Efficient Computation on Nonlinear Responses of a Rotating Assembly Incorporating the Squeeze-Film Damper,” Comput. Methods Appl. Mech. Eng., 164, pp. 363–373.
Nataraj,  C., and Nelson,  H. D., 1989, “Periodic Solutions in Rotor Dynamic Systems With Nonlinear Supports: A General Approach,” ASME J. Vibr. Acoust., 111, pp. 187–193.
El-Shafei,  A., and Eranki,  R. V., 1994, “Dynamic Analysis of Squeeze Film Damper Supported Rotors Using Equivalent Linearization,” ASME J. Eng. Gas Turbines Power, 116, pp. 682–691.
Zhao,  J. Y., Linnet,  I. W., and McLean,  L. J., 1994, “Stability and Bifurcation of Unbalanced Response of a Squeeze Film Damped Flexible Rotor,” ASME J. Tribol., 116, pp. 361–368.
Hahn,  E. J., and Chen,  P. Y. P., 1994, “Harmonic Balance Analysis of General Squeeze Film Damped Multidegree-of-Freedom Rotor Bearing Systems,” ASME J. Tribol., 116, pp. 499–507.
Shiau,  T. N., Hwang,  J. L., and Chang,  Y. B., 1993, “A Study on Stability and Response Analysis of a Nonlinear Rotor System With Mass Unbalance and Side Load,” ASME J. Eng. Gas Turbines Power, 115, pp. 218–226.
Tichy,  J. A., 1987, “A Study of the Effect of Fluid Inertia and End Leakage in the Finite Squeeze Film Damper,” ASME J. Tribol., 109, pp. 54–59.
Jung,  S. Y., San Andrés,  L. A., and Vance,  J. M., 1991, “Measurements of Pressure Distributions and Force Coefficients in a Squeeze Film Damper Part II: Partially Sealed Configuration,” Tribol. Trans., 34, pp. 383–388.
Rezvani,  M. A., and Hahn,  E. J., 1993, “Limitations of the Short Bearing Approximation in Dynamically Loaded Narrow Hydrodynamic Bearing,” ASME J. Tribol., 115, pp. 544–549.
O’Donoghue,  J. P., Koch,  P. R., and Hooke,  C. O., 1969–1970, “Approximate Short Bearing Analysis and Experimental Results Obtained Using Plastic Bearing Liners,” Proc. Inst. Mech. Eng., 184, Pt. 3L, pp. 190–196.
Rohde,  S. M., and Li,  D. F., 1980, “A Generalized Short Bearing Theory,” J. Lubr. Technol., 102, pp. 278–282.
Barret,  L. E., Allaire,  P. E., and Gunter,  E. J., 1980, “A Finite Length Bearing Correction Factor for Short Bearing Theory,” J. Lubr. Technol., 102, pp. 283–290.
Fuerst, A., Weber, H. I., and Brito, G. C., 1998, “Application and Remarks on the Finite Bearing Solution (FBS),” IFToMM Fifth International Conference on Rotor Dynamics, Darmstadt, pp. 560–570.
Arauz,  G. L., and San Andrés,  L. A., 1993, “Experimental Pressures and Film Forces in a Squeeze Film Damper,” ASME J. Tribol., 115, pp. 134–140.
Amendola, M., 1996, “Cavitation in Hydrodynamic Lubrication: A Parallel Algorithm for a Free-Boundary Problem,” PhD thesis, IMECC-Unicamp.
Reinhardt,  E., and Lund,  J. W., 1975, “The Influence of Fluid Inertia on the Dynamic Properties of Journal Bearings,” J. Lubr. Technol., 97, pp. 159–167.
El-Shafei,  A., 1991, “Unbalance Response of a Jeffcott Rotor Incorporating Long Squeeze Film Dampers,” ASME J. Vibr. Acoust., 113, pp. 85–94.
Ramesh, K., and Kirk, G., 1999, “Nonlinear Response of Rotors Supported on Squeeze Film Dampers,”Proceedings of DETC99 17th Biennial ASME Vibrations Conference, Las Vegas, NV.
Inayat-Hussain, J. I., Kanki, H., and Mureithi, N. W., 1999, “On The Effectiveness of Squeeze-Film Dampers for Vibration Attenuation in Rotating Machinery,” Proceedings of Inter-Noise 99, Fort Lauderdale, FL.
Chu,  F., and Holmes,  R., 2000, “The Damping Capacity of the Squeeze Film Damper in Suppressing Vibration of a Rotating Assembly,” Tribol. Int., 33, pp. 81–97.
Szeri,  A. Z., Raimondi,  A. A., and Giron-Duarte,  A., 1983, “Linear Force Coefficients for Squeeze-Film Dampers,” J. Lubr. Technol., 105, pp. 326–334.
San Andres,  L., and Vance,  J. M., 1987, “Effects of Fluid Inertia on Finite Length Squeeze-Film Dampers,” ASLE Trans., 30, pp. 384–393.
Gohar, R., 1988, Elastohydrodynamics, (Ellis Horwood Series in Mechanical Engineering), Ellis Horwood, Chicester, UK.
Cookson,  R. A., Feng,  X. H., and Kossa,  S. S., 1983, “The Effect of Journal Misalignment on the Oil-Film Forces Generated in a Squeeze Film Damper,” ASME J. Eng. Gas Turbines Power, 105, pp. 560–564.
Zhang,  S., and Yan,  L., 1991, “Development of an Efficient Oil Film Damper for Improving the Control of Rotor Vibration,” ASME J. Eng. Gas Turbines Power, 113, pp. 557–562.
Chamniprasart,  K., Al-Sharif,  A., Rajagopal,  K. R., and Szeri,  A. Z., 1993, “Lubrication With Binary Mixtures: Bubbly Oil,” ASME J. Tribol., 115, pp. 253–260.
Jaw-Ren,  Lin, 1998, “Squeeze Film Characteristics on Finite Journal Bearings: Couple Stress Fluid Model,” Tribol. Int., 31, pp. 201–207.
Worden, K., and Tomlinson, G. R., 1988, “Developments in Force State Mapping for Nonlinear Systems,”Proceedings, VI International Modal Analysis Conference, pp. 1471–1479.
McLean,  L. J., and Hahn,  E. J., 1983, “Unbalance Behavior of Squeeze Film Damped Multi-Mass Flexible Rotor Bearing Systems,” ASME J. Lubr. Technol., 105, pp. 22–28.
Ren,  Y., and Beards,  C. F., 1994, “A New Receptance-Based Perturbative Multi-Harmonic Balance Method for the Calculation of the Steady State Response of Non-Linear Systems,” J. Sound Vib., 172, pp. 593–605.
Nayfeh, A. H., and Balachandran, B., 1995, Applied Nonlinear Dynamics, John Wiley and Sons, New York.
Wang,  J., and Hahn,  E. J., 1995, “Transient Analysis of Squeeze-Film Dampers With Oil Hole Feed,” Tribol. Trans., 38, pp. 837–844.
Arauz,  G. L., and San Andrés,  L., 1994, “Effect of a Circumferential Feeding Groove on the Dynamic Force Response of a Short Squeeze Film Damper,” ASME J. Tribol., 116, pp. 369–377.
Murty,  K. G., 1974, “Note on a Bard-Type Scheme for Solving the Complementarity Problems,” Opsearch, 11, pp. 123–130.
Freund,  N. O., and Tieu,  A. K., 1993, “A Thermo-Elasto-Hydrodynamic Study of Journal Bearing With Controlled Deflection,” ASME J. Tribol., 115, pp. 550–556.

Figures

Grahic Jump Location
Schematic view of a squeeze film damper (SFD)
Grahic Jump Location
Cross section and coordinate frames of the squeeze film damper (SFD)
Grahic Jump Location
Squeeze film damped flexible rotor—Jeffcott model
Grahic Jump Location
Inspection of the fit quality: radial force function of ė and ϕ̇ for ε=0.5
Grahic Jump Location
Inspection of the fit quality: radial force relative error at quadrature points
Grahic Jump Location
Comparison of unbalance responses calculated using different squeeze film damper (SFD) forces models
Grahic Jump Location
Stability analysis results for different squeeze film damper (SFD) forces models
Grahic Jump Location
Comparison of quasi-periodic orbits obtained by numerical integration for ωad=2.3
Grahic Jump Location
Comparison of results obtained by the finite difference method and the Chebyshev polynomials fit

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In