Internal Combustion Engines

Effect of Hydrocarbon Emissions From PCCI-Type Combustion on the Performance of Selective Catalytic Reduction Catalysts

[+] Author and Article Information
Vitaly Y. Prikhodko1

Oak Ridge National Laboratory, Oak Ridge, TNprikhodkovy@ornl.gov

Josh A. Pihl, Samuel A. Lewis, James E. Parks

Oak Ridge National Laboratory, Oak Ridge, TN

“Fouling”: catalyst deactivation mechanism described by Bartholomew as “the physical (mechanical) deposition of species from the fluid phase onto the catalyst surface, which results in activity loss due to blockage of sites and/or pores.” [7].


Corresponding author.

J. Eng. Gas Turbines Power 134(8), 082804 (Jun 19, 2012) (5 pages) doi:10.1115/1.4006003 History: Received October 28, 2011; Revised October 31, 2011; Published June 19, 2012; Online June 19, 2012

Core samples cut from full size commercial Fe-and Cu- zeolite selective catalytic reduction catalysts were exposed to a slipstream of raw engine exhaust from a 1.9-liter 4-cylinder diesel engine operating in conventional and premixed charge compression ignition (PCCI) combustion modes. Subsequently, the NOx reduction performance of the exposed catalysts was evaluated on a laboratory bench-reactor fed with simulated exhaust. The Fe-zeolite NOx conversion efficiency was significantly degraded, especially at low temperatures (<250 °C), after the catalyst was exposed to the engine exhaust. The degradation of the Fe-zeolite performance was similar for both combustion modes. The Cu-zeolite was much more resistant to hydrocarbon (HC) fouling than the Fe-zeolite catalyst. In the case of the Cu-zeolite, PCCI exhaust had a more significant impact than the exhaust from conventional combustion on the NOx conversion efficiency. For all cases, the clean catalyst performance was recovered after heating to 600 °C. Gas chromatography mass spectrometry analysis of the HCs adsorbed to the catalyst surface provided insights into the observed NOx reduction performance trends.

Copyright © 2012 by American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.



Grahic Jump Location
Figure 1

Cu-zeolite NOx conversion as a function of temperature for various states of catalyst exposure

Grahic Jump Location
Figure 2

Cu-zeolite NOx conversion as a function of temperature for various states of catalyst exposure

Grahic Jump Location
Figure 3

Hydrocarbon release during a temperature ramp of the Cu-zeolite catalyst after exposure to PCCI exhaust; release is observed as hydrocarbon and CO+CO2 species

Grahic Jump Location
Figure 4

Integrated C released from Cu- and Fe-zeolite catalysts after exposure to both conventional and PCCI combustion

Grahic Jump Location
Figure 5

Moles of NH3 stored on the SCR catalyst at various stages of the experimental study

Grahic Jump Location
Figure 6

GC-MS trace of hydrocarbons extracted from the Cu-zeolite catalyst after exposure to (a) conventional and (b) PCCI combustion exhaust

Grahic Jump Location
Figure 7

Magnitude of hydrocarbons adsorbed onto a Cu-zeolite core as a function of length along the flow axis as measured with DRIFTS



Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In