... the driving voltage was varied between 50 and 90 V RMS . Two different heater powers, corresponding to approximately 50 and 80 °C, were tested. A square heater with a surface area of 156 mm 2 was used to mimic the hot component and detailed temperature measurements were obtained with a microscopic infrared...

... element analysis simulation results were compared with the temperatures, and with experimental measurements were found to be in agreement with the simulated values. 04 03 2004 04 08 2004 thermal management (packaging) finite element analysis temperature sensors temperature measurement...

...Ronan Grimes; Mark Davies In this paper, measurements of surface temperature and air velocity are presented for the case of a printed circuit board with heated metal elements in a fan-induced flow. Surface temperature measurements were performed using infra red thermography, while air flow...

... is dissipated by natural convection/radiation to the ambient and conduction losses along the thermocouples at steady state conditions. The temperatures measured by each pixel of the IR detector focused on the handset were used to compute the radiation heat transfer rate from each side of the handset, i.e., (4...