A propane-fueled research combustor has been designed to represent the essential features of primary zones of combustors for aircraft gas turbine engines in an investigation of lean blowouts. The atmospheric pressure test facility being used for the investigation made it difficult to approach the maximum heat release condition of the research combustor directly. High combustor loadings were achieved through simulating the effects on chemical reaction rates of subatmospheric pressures by means of a nitrogen diluent technique. A calibration procedure is described, and correlated experimental lean blowout results are compared with well-stirred reactor calculations for the research combustor to confirm the efficacy of the calibration.

Issue Section:
Gas Turbines: Combustion and Fuels
Topics:
Combustion chambers, Calibration, Aircraft, Atmospheric pressure, Chemical kinetics, Diluents, Gas turbines, Heat, Nitrogen, Test facilities
1.
Bragg, S. L., 1953, Aeronautical Research Council, Paper No. 16170, CF 272, U.K., Sept.
2.
Clarke, A. E., Odgers, J., and Ryan, P., 1960, “Further Studies of Combustion Phenomena in a Spherical Reactor,” Proc. 8th Symposium (International) on Combustion, The Combustion Institute, pp. 983–994.
3.
Greenhough, V. W., and Lefebvre, A. H., 1956, “Some Applications of Combustion Theory to Gas Turbine Development,” Proc. Sixth Symposium (International) on Combustion, Reinhold Publishing Co., pp. 858–869.
4.
Heneghan, S. P., Vangsness, M. D., Ballal, D. R., Lesmerises, A. L., and Sturgess, G. J., 1990, “Acoustic Characteristics of a Research Step Combustor,” AIAA Paper No. AIAA-90-1851.
5.
Herbert, M. V., 1960, “A Theoretical Analysis of Reaction Rate Controlled Systems; Part II,” Proc. 8th Symposium (International) on Combustion, The Combustion Institute, pp. 970–982.
6.
Kretschmer, D., and Odgers, J., 1972, “Modeling of Gas Turbine Combustors—A Convenient Reaction Rate Equation,” ASME JOURNAL OF ENGINEERING FOR POWER, pp. 173–180.
7.
Lefebvre, A. H., and Halls, G. A., 1959, “Simulation of Low Combustion Pressures by Water Injection,” Proc. Seventh Symposium (International) on Combustion, Butterworths Scientific Publications, London, pp. 654–658.
8.
Lefebvre, A. H., 1961, “Some Simple Techniques for the Performance Evaluation of Gas Turbine Combustion Systems,” Experimental Methods in Combustion Research, J. Surugue, ed., AGARD, Pergamon Press.
9.
Lewis, B., and von Elbe, G., 1987, Combustion, Flames and Explosion of Gases, 3rd ed., Academic Press.
10.
Longwell
J. P.
,
Frost
E. E.
, and
Weiss
M. A.
,
1953
, “
Flame Stability in Bluff-Body Recirculation Zones
,”
Ind. Eng. Chem.
, Vol.
45
, No.
8
, pp.
1629
–
1633
.
11.
Norster, E. R., 1968, “Subsonic Flow Flameholder Studies Using a Low Pressure Simulation Technique,” Proc. Intl. Prop. Symp. Combustion in Advanced Gas Turbine Systems, I. E. Smith, ed., Cranfield Intl. Symp. Series, Vol. 10, Pergamon Press, pp. 79–94.
12.
Pratt, D. T., and Wormeck, J. J., 1976, “CREK—A Computer Program for Calculation of Combustion Reaction Equilibrium and Kinetics in Laminar or Turbulent Flow,” Rpt. No. WSU-ME-TEL-76, Dept. Mech. Engrg., Washington State University.
13.
Roberts
R.
,
Aceto
L. D.
,
Kollrack
R.
,
Teixeira
D. P.
, and
Bonnell
J. M.
,
1972
, “
An Analytical Model for Nitric Oxide Formation in a Gas Turbine Combustor
,”
AIAA J.
, Vol.
10
, No.
6
, pp.
820
–
826
.
14.
Sturgess
G. J.
,
Sloan
D. G.
,
Lesmerises
A. L.
,
Heneghan
S. P.
, and
Ballal
D. R.
,
1992
, “
Design and Development of a Research Combustor for Lean Blow Out Studies
,”
ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER
, Vol.
114
, pp.
13
–
19
.
15.
Swithenbank, J., 1974, “Flame Stabilization in High Velocity Flow,” Combustion Technology—Some Modern Developments, H. B. Palmer and J. M. Beer, eds., Academic Press, pp. 191–125.
This content is only available via PDF.
Copyright © 1996
 by The American Society of Mechanical Engineers
You do not currently have access to this content.