A coupled Lagrangian Monte Carlo Probability Density Function (PDF)-Eulerian Computational Fluid Dynamics (CFD) technique is presented for calculating steady three-dimensional turbulent reacting flow in a gas turbine combustor. PDF transport methods model turbulence-combustion interactions more accurately than conventional turbulence models with an assumed shape PDF. The PDF transport equation was solved using a Lagrangian particle tracking Monte Carlo (MC) method. The PDF modeled was over composition only. This MC module has been coupled with CONCERT, which is a fully elliptic three-dimensional body-fitted CFD code based on pressure correction techniques. In an earlier paper (Tolpadi et al., 1995), this computational approach was described, but only fast chemistry calculations were presented in a typical aircraft engine combustor. In the present paper, reduced chemistry schemes were incorporated into the MC module that enabled the modeling of finite rate effects in gas turbine flames and therefore the prediction of CO and NOx emissions. With the inclusion of these finite rate effects, the gas temperatures obtained were also more realistic. Initially, a two scalar scheme was implemented that allowed validation against Raman data taken in a recirculating bluff body stabilized CO/H2/N2-air flame. Good agreement of the temperature and major species were obtained. Next, finite rate computations were performed in a single annular aircraft engine combustor by incorporating a simple three scalar reduced chemistry scheme for Jet A fuel. This three scalar scheme was an extension of the two scalar scheme for CO/H2/N2 fuel. The solutions obtained using the present approach were compared with those obtained using the fast chemistry PDF transport approach (Tolpadi et al., 1995) as well as the presumed shape PDF method. The calculated exhaust gas temperature using the finite rate model showed the best agreement with measurements made by a thermocouple rake. In addition, the CO and NOx emission indices were also computed and compared with corresponding data.

Issue Section:
Gas Turbines: Combustion and Fuels
Topics:
Chemistry, Combustion chambers, Computation, Computational fluid dynamics, Gas turbines, Scalars, Temperature, Turbulence, Aircraft engines, Emissions, Flames, Fuels, Nitrogen oxides, Shapes, Combustion, Density, Exhaust systems, Flow (Dynamics), Modeling, Particulate matter, Pressure, Probability, Thermocouples
1.
Anand, M. S., Pope, S. B., and Mongia, H. C., 1990, “Pressure Algorithm for Elliptic Flow Calculations With the PDF Method,” CFD Symposium on Aeropropulsion at NASA-Lewis.
2.
Borghi
R.
,
1988
, “
Turbulent Combustion Modeling
,”
Prog. Energy Combust. Sci.
, Vol.
14
, pp.
245
–
292
.
3.
Correa
S. M.
, and
Shyy
W.
,
1987
, “
Computational Models and Methods for Continuous Gaseous Turbulent Combustion
,”
Prog. Energy Combust. Sci.
, Vol.
13
, pp.
249
–
292
.
4.
Correa
S. M.
, and
Gulati
A.
,
1992
, “
Measurements and Modeling of a Bluff Body Stabilized Flame
,”
Combust. Flame
, Vol.
89
, pp.
195
–
213
.
5.
Correa, S. M., and Pope, S. B., 1992, “Comparison of Monte Carlo PDF/Finite Volume Mean Flow Model With Bluff Body Raman Data,” 24th Intl. Symp. on Combust., pp. 279–285.
6.
Correa
S. M.
,
1995
, “
Assessment of a Three-Variable Reduced Kinetic Scheme in Prescribed Turbulence
,”
AIAA J. Prop. & Power
, Vol.
11
, No.
3
, pp.
448
–
455
.
7.
Gulati
A.
,
Tolpadi
A. K.
,
VanDeusen
G.
, and
Burrus
D.
,
1995
, “
Effect of Dilution Air on Scalar Flowfield at Combustor Sector Exit
,”
AIAA J. Prop. & Power
, Vol.
11
, No.
6
, pp.
1162
–
1169
.
8.
McDonell, V. G., Samuelsen, G. S., and Seay, J. E., 1994, “Characterization of the Nonreacting Two Phase Flow Downstream of a Aeroengine Combustor Dome Operating at Realistic Conditions,” ASME Paper No. 94-GT-263.
9.
Pope
S. B.
,
1985
, “
PDF Methods for Turbulent Reactive Flows
,”
Prog. Energy Combust. Sci.
, Vol.
11
, pp.
119
–
192
.
10.
Pope, S. B., and Correa, S. M., 1986, “Joint PFD Calculations of a Non-equilibrium Turbulent Diffusion Flame,” 21st Intl. Symp. on Combust., pp. 1341–1348.
11.
Pope, S. B., 1990, “Computations of Turbulent Combustion: Progress and Challenges,” 23rd Intl. Symp. on Combust., pp. 591–612.
12.
Shyy
W.
,
Tong
S. S.
, and
Correa
S. M.
,
1985
, “
Numerical Recirculating Flow Calculations Using a Body-Fitted Coordinate System
,”
Numer. Heat Trans.
, Vol.
8
, pp.
99
–
113
.
13.
Shyy
W.
, and
Braaten
M. E.
,
1986
, “
Three-Dimensional Analysis of the Flow in a Curved Hydraulic Turbine Draft Tube
,”
Intl. J. Numer. Meths. Fluids
, Vol.
6
, pp.
861
–
882
.
14.
Shyy
W.
,
Correa
S. M.
, and
Braaten
M. E.
,
1988
, “
Computation of Flow in a Gas Turbine Combustor
,”
Combust. Sci. and Tech.
, Vol.
58
, pp.
97
–
117
.
15.
Spadaccini, L. J. and TeVelde, J. A., 1980, “Auto-Ignition Characteristics of Aircraft-Type Fuels,” NASA-CR-159886.
16.
Tolpadi
A. K.
, and
Braaten
M. E.
,
1992
, “
Study of Branched Turboprop Inlet Ducts Using a Multiple Block Grid Calculation Procedure
,”
ASME Journal of Fluids Engineering
, Vol.
114
, pp.
379
–
385
.
17.
Tolpadi
A. K.
,
1995
, “
Calculation of Two-Phase Flow in Gas Turbine Combustors
,”
ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER
, Vol.
117
, pp.
695
–
703
.
18.
Tolpadi
A. K.
,
Correa
S. M.
,
Burrus
D. L.
, and
Mongia
H. C.
,
1997
, “
Monte Carlo Probability Density Function Method for Gas Turbine Combustor Flowfield Predictions
,”
AIAA J. Prop. & Power
, Vol.
13
, No.
2
, pp.
218
–
225
.
This content is only available via PDF.
Copyright © 1997
 by The American Society of Mechanical Engineers
You do not currently have access to this content.