This paper shows that the geometry of the heat flow path between a volume and one point can be optimized in two fundamentally different ways. In the “growth” method of the original constructal theory the structure is optimized starting from the smallest volume element of fixed size. Growth, or optimal numbers of constituents assembled into larger volumes, is one route to resistance minimization. In the “design” method the overall volume is fixed, and the designer works “inward” by optimizing the internal features of the heat flow path. The design method is new. It is shown analytically that the two methods produce comparable geometric results in which the high-conductivity channels form constructal tree networks, and where the low-conductivity material fills the interstices. For simplicity, it is assumed that the high-conductivity channels and their tributaries make 90-deg angles. In both approaches, the overall resistance decreases as the internal complexity of the conductive composite increases. In the growth method the number of constituents in each assembly can be optimized. In the design method, some of the constituent numbers cannot be optimized: these numbers assume the roles of weak parameters. The growth method is the simplest, and provides a useful approximation of the design and performance that can be achieved using the design method. Numerical solutions of the volume-to-point optimization problem confirm the results obtained analytically, and show that the geometric features of the optimal design are robust.
Skip Nav Destination
Article navigation
Research Papers
Two Constructal Routes to Minimal Heat Flow Resistance via Greater Internal Complexity
A. Bejan,
A. Bejan
Department of Mechanical Engineering and Materials Science, Duke University, Durham, NC 27708-0300
Search for other works by this author on:
N. Dan
N. Dan
Department of Mechanical Engineering and Materials Science, Duke University, Durham, NC 27708-0300
Search for other works by this author on:
A. Bejan
Department of Mechanical Engineering and Materials Science, Duke University, Durham, NC 27708-0300
N. Dan
Department of Mechanical Engineering and Materials Science, Duke University, Durham, NC 27708-0300
J. Heat Transfer. Feb 1999, 121(1): 6-14 (9 pages)
Published Online: February 1, 1999
Article history
Received:
January 14, 1998
Revised:
August 20, 1998
Online:
December 5, 2007
Citation
Bejan, A., and Dan, N. (February 1, 1999). "Two Constructal Routes to Minimal Heat Flow Resistance via Greater Internal Complexity." ASME. J. Heat Transfer. February 1999; 121(1): 6–14. https://doi.org/10.1115/1.2825968
Download citation file:
Get Email Alerts
Cited By
Entropic Analysis of the Maximum Output Power of Thermoradiative Cells
J. Heat Mass Transfer
Molecular Dynamics Simulations in Nanoscale Heat Transfer: A Mini Review
J. Heat Mass Transfer
Related Articles
Constructal Trees of Convective Fins
J. Heat Transfer (August,1999)
A Review of Recent Developments in Some Practical Aspects of Air-Cooled Electronic Packages
J. Heat Transfer (November,1998)
Evaluation of Combined Heat and Mass Transfer Effect on the Thermoeconomic Optimization of an Air-Conditioning Rotary Regenerator
J. Heat Transfer (August,2003)
Free Convection Limits for Pin-Fin Cooling
J. Heat Transfer (August,1998)
Related Proceedings Papers
Related Chapters
Introduction
Thermal Management of Microelectronic Equipment
Thermal Interface Resistance
Thermal Management of Microelectronic Equipment
Herbie's Homework Helpers
Hot Air Rises and Heat Sinks: Everything You Know about Cooling Electronics Is Wrong