The trend towards increasing heat flux at the chip and module level in computers is continuing. This trend coupled with the desire to increase performance by reducing chip operating temperatures presents a further challenge to thermal engineers. This paper will provide an assessment of the potential for module cooling enhancement with thermoelectric coolers. A brief background discussion of thermoelectric cooling is provided citing some of the early history of thermoelectrics as well as more recent developments from the literature. An example analyzing cooling enhancement of a multichip module package with a thermoelectric cooler is discussed. The analysis utilizes closed form equations incorporating both thermoelectric cooler parameters and package level thermal resistances to relate allowable module power to chip temperature. Comparisons are made of allowable module power with and without thermoelectric coolers based upon either air or water module level cooling. These results show that conventional thermoelectric coolers are inadequate to meet the requirements. Consideration is then given to improvements in allowable module power that might be obtained through increases in the thermoelectric figure of merit ZT or miniaturization of the thermoelectric elements.

Keywords:
thermoelectric conversion, multichip modules, cooling, thermal resistance, thermoelectric devices, thermoelectricity
Topics:
Cooling, Temperature, Thermoelectric coolers, Thermoelectric cooling, Heat, Multi-chip modules, Geometry, Water
1.
Gaensslen, F. H., 1980, “MOS Devices and Integrated Circuits at Liquid Nitrogen Temperature,” 1980 IEEE ICCD Proceedings, pp. 450–452.
2.
Jaeger, R. C., 1986, “Development of Low Temperature CMOS for High Performance Computer Systems,” IEEE International Conference on Computer Design: VLSI in Computers, pp. 128–130.
3.
Kirschmann, R. K., 1986, “Development of Low Temperature CMOS for High Performance Computer Systems,” IEEE International Conference on Computer Design: VLSI in Computers, pp. 128–130.
4.
Krane, R. J., Bar-Cohen, A., Jaeger, R. C., and Gaensslen, F. H., 1990, “MOS Electronics and Thermal Control for Cryogenically-Cooled Computer Systems,” in Advances in Thermal Modeling of Electronic Components and Systems, 2, ASME Press, New York, NY, pp. 185–232.
5.
Taur, Y., and Nowak, E. J., 1997, “CMOS Devices Below 0.1 μm: How High Will Performance Go?,” Electron Devices Meeting Technical Digest, IEEE, Piscataway, NJ, pp. 215–218.
6.
Nolas, G. S., Slack, G. A., Cohn, J. L., and Schujman, S. B., 1998, “The Next Generation of Thermoelectric Materials,” Proceedings of the 17th International Conference on Thermoelectrics, IEEE, Piscataway, NJ, pp. 294–297.
7.
Kraus, A. D., 1965, Cooling Electronic Equipment, Prentice-Hall, New York, NY.
8.
Dubois, L. H., 1999, “An Introduction to the DARPA Program in Advanced Thermoelectric Materials and Devices,” Proceedings of 18th International Conference on Thermoelectrics, IEEE, Piscataway, NJ, pp. 1–4.
9.
Kolander, W. L., and Lyon, H. B., 1996, “Thermoelectric Cooler Utility for Electronic Applications,” ASME HTD-Vol. 239, National Heat Transfer Conference, 7, ASME, New York.
10.
Vandersande, J. W., and Fleurial, J.-P., “Thermal Management of Power Electronics Using Thermoelectric Coolers,” Proceedings of the 15th International Conference on Thermoelectrics, IEEE, Piscataway, NJ, pp. 252–255.
11.
Stockholm, J. G., 1997, “Current State of Peltier Cooling,” Proceedings of the 16th International Conference on Thermoelectrics, pp. 37–46.
12.
Fleurial, J.-P., Borshchevsky, A., Caillat, T., and Ewell, R., 1997, “New Materials and Devices for Thermoelectric Applications,” IECEC, ACS Paper No. 97419, pp. 1080–1085.
13.
Dresselhaus, M. S., Koga, T., Sun, X., Cronin, S. B., Wang, Cronin, S. B., Wang, K. L., and Chen, G., 1997, “Low Dimensional Thermoelectrics,” Proceedings of the 16th International Conference on Thermoelectrics, IEEE, Piscataway, NJ, pp. 12–20.
14.
Morelli, D. T., 1996, “Potential Applications of Advanced Thermoelectrics in the Automobile Industry,” Proceedings of the 13th International Conference on Thermoelectrics, pp. 383–386.
15.
Chu, R. C., and Simons, R. E., 1994, “Cooling Technology for High Performance Computers: Design Applications,” in Cooling of Electronic Systems, S. Kakac, H. Yuncu, and K. Hijikata, eds., Kluwer Academic Publishers, Dordrecht, Netherlands, pp. 71–95.
16.
Phelan, P. E., Chiriac, V., and Lee, T.-Y., 1996, “Current and Future Miniature Refrigeration Cooling Technologies for High Power Microelectronics,” Proceedings of the 17th Semiconductor Thermal Measurement and Management Symposium, IEEE, Piscataway, NJ, pp. 158–167.
Copyright © 2005
 by ASME
You do not currently have access to this content.