An experimental investigation of a fluidized bed with multiple cooling pipes was conducted to study adsorption characteristics of a new organic sorbent desiccant material (HU300P) for a new air conditioning system. The mass ratio of the present sorbent desiccant powder type is from 1.3 to 2.3 times greater than that of silica gel. The sorption rate of the water vapor in the sorbent bed was measured under various conditions. It was found that the sorption rate is highly dependent on the effect of cooling pipes. The sorption ratio increases and the completion time for the sorption process decreases by using multiple cooling pipes.
Issue Section:
Technical Briefs
1.
Inaba
, H.
, 1998, “Heat and Mass Transfer Characteristics of New Adsorption Polymers for Advanced Adsorption Cycle
,” Therm. Sci. Eng.
0918-9963, 6
(1
), pp. 11
–18
.2.
Henning
, H. M.
, Erpenbeck
, T.
, Hindenburg
, C.
, and Santamaria
, I. S.
, 2001, “The Potential of Solar Energy Use in Desiccant Cooling Cycles
,” Int. J. Refrig.
0140-7007, 24
, pp. 220
–229
.3.
Shu
, J.
, Ruzhu
, W.
, Yunzhuang
, L.
, and Jingyi
, W.
, 2006, “Operational Aspects of Adsorption Air-Conditioner Used in Diesel Locomotive
,” Int. J. Energy Res.
, 30
, pp. 1377
–1390
. 0363-907X4.
Inaba
, H.
, Horibe
, A.
, Kameda
, K.
, Haruki
, N.
, and Kida
, T.
, 2000, “Heat and Mass Transfer of a Fluidized Bed Packed With Organic Powder Type Adsorption Material
,” Proceedings of the Symposium on Energy Engineering in the 21st Century
, Hongkong
, Jan. 9–13.5.
Hamed
, A. M.
, 2005, “Experimental Investigation on the Adsorption/Desorption Processes Using Solid Desiccant in an Inclined Fluidized Bed
,” Renewable Energy
0960-1481, 30
, pp. 1913
–1921
.6.
Moskal
, F.
, and Nastaj
, J. F.
, 2007, “Internal Heat Source Capacity at Inductive Heating in Desorption Step of ETSA Process
,” Int. Commun. Heat Mass Transfer
0735-1933, 34
, pp. 579
–586
.7.
Horibe
, A.
, Husain
, S.
, Inaba
, H.
, and Haruki
, N.
, 2008, “Sorption Characteristics of Organic Powder Sorption Material in Fluidized Bed With a Cooling Pipe
,” J. Thermal Science and Technology
, 3
(2
), pp. 207
–218
.Copyright © 2008
by American Society of Mechanical Engineers
You do not currently have access to this content.