1-20 of 20
Keywords: corrosion
Close
Sort by
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Tribol. September 2024, 146(9): 091701.
Paper No: TRIB-23-1396
Published Online: May 15, 2024
... in the food industry. The tests were carried out using samples of steel uncoated and coated with tungsten oxynitride in a pin-on-disc configuration using a tailored tribocorrosion cell. The uncoated AISI 431 presented good wear and corrosion resistance but presented tribocorrosion degradation, where...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Tribol. April 2023, 145(4): 041701.
Paper No: TRIB-22-1325
Published Online: December 6, 2022
... by abrasion, delamination, and oxidation. In particular, the wear-rate of Cu-based BMG is about 22 times lower than that of conventional NAB when sliding in the air under a load of 5 N. When sliding in 3.5 wt% NaCl solution, Cu-based BMG demonstrates better static-corrosion resistance but worse tribocorrosion...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Tribol. May 2022, 144(5): 051401.
Paper No: TRIB-21-1373
Published Online: November 25, 2021
...Peter Renner; Swarn Jha; Yan Chen; Tariq Chagouri; Serge Kazadi; Mohamed Gharib; Hong Liang Effective design of corrosion-resistant coatings is critical for the protection of metals and alloys. Many state-of-the-art corrosion-resistant coatings are unable to satisfy the challenges in extreme...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Tribol. February 2022, 144(2): 021204.
Paper No: TRIB-21-1283
Published Online: October 26, 2021
... lubrication of PAM. COF of shale rock under PAM brine solution increases and the wear of the rock is more serious, attributed to the corrosion of shale rock and adverse effect on lubrication of PAM by brine. Email: ZhangHuijie2018@163.com Email: liu_shu_hai@163.com Contributed by the Tribology...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Tribol. November 2021, 143(11): 111702.
Paper No: TRIB-21-1123
Published Online: June 18, 2021
...Renato B. Pessoa; Carlos A. H. Laurindo; Michelle S. Meruvia; Ricardo D. Torres; Alexandre Mikowski; Marcos E. Soares; Paulo Soares In this study, the influence of Al 2 O 3 particle amounts on the mechanical, tribological, and corrosion properties of the composite NiP-Al 2 O 3 coating was evaluated...
Journal Articles
Publisher: ASME
Article Type: Review Articles
J. Tribol. September 2021, 143(9): 090801.
Paper No: TRIB-20-1519
Published Online: May 25, 2021
...–corrosion, and abrasion occur in different industries like thermal and hydro power plants, mining, chemical, and marine industries. Therefore, the efficiency of these industries and power plants highly depends on the wear damages. So, it becomes necessary to govern the wear phenomenon. In this paper...
Journal Articles
Publisher: ASME
Article Type: Review Articles
J. Tribol. May 2021, 143(5): 050802.
Paper No: TRIB-20-1539
Published Online: April 1, 2021
..., in particular, corrosion and wear seen in most engineering applications. The haphazard and inefficient usage of such alloys raised concerns about safety, compatibility, reliability, cost, and consumer satisfaction. To address those concerns, we studied the mechanisms of the most common failure modes, corrosion...
Journal Articles
Publisher: ASME
Article Type: Technical Briefs
J. Tribol. July 2021, 143(7): 074501.
Paper No: TRIB-20-1172
Published Online: November 5, 2020
...Xuefeng Song; Ying Liu; Xiaoyan Wang; Erlin Zhang CoCrMo alloy containing copper element can significantly improve the antibacterial property of the alloy. However, most metal implants often fail due to the presence of corrosion and wear. In this work, the electrochemical and tribocorrosion...
Includes: Supplementary data
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Tribol. April 2019, 141(4): 041607.
Paper No: TRIB-18-1411
Published Online: January 25, 2019
...Ankitendran Mishra; Dhananjay Pradhan; C. K. Behera; S. Mohan; A. Mohan This study presents the prehot corrosion effect on erosion behavior of AISI 446 SS in simulated heat exchanger environment at elevated temperature. Samples were spray deposited using two salt mixture (Na 2 SO 4 /NaCl...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Tribol. November 2018, 140(6): 061609.
Paper No: TRIB-17-1485
Published Online: June 13, 2018
...N. Khayatan; H. M. Ghasemi; M. Abedini The erosion–corrosion (EC) and pure erosion of commercially pure titanium have been investigated in a 3.5% sodium chloride solution containing 10, 30, and 60 g/l SiO 2 particles with an average size of 318 μ m. The tests were performed at impact velocities...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Tribol. November 2017, 139(6): 061302.
Paper No: TRIB-16-1301
Published Online: June 30, 2017
... IEP value of Co 3 O 4 so that the latter particles carried net positive surface charge. The coated surfaces were subjected to various tests, i.e., microhardness, wear/friction, and corrosion. Results revealed that irrespective of the amount of the embedded Co 3 O 4 particles, nanocomposite coatings...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Tribol. November 2017, 139(6): 061801.
Paper No: TRIB-16-1293
Published Online: June 30, 2017
...Zhengfeng Cao; Yanqiu Xia Polyaniline (PANI) was doped as lubricating additive to afford grease. The effect of PANI on the physicochemical characteristics, corrosion resistance, and tribological performances of lubricating grease was investigated in details, and the tribological action mechanisms...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Tribol. May 2017, 139(3): 031303.
Paper No: TRIB-16-1120
Published Online: November 30, 2016
...A. R. Hemmati; M. Soltanieh; S. M. Masoudpanah In this study, the effect of flow velocity (4–7.5 m s −1 ) and impact angle (30–90 deg) on erosion–corrosion behavior of chromium carbide coating was investigated under impingement by silica containing NaCl solution. Chromium carbide coating...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Tribol. January 2017, 139(1): 011105.
Paper No: TRIB-15-1291
Published Online: August 16, 2016
...A. Pasha; H. M. Ghasemi; J. Neshati A slurry impingement rig containing 6 wt.% SiO 2 particles was used to investigate synergistic erosion–corrosion behavior of X-65 carbon steel at various impingement angles. Maximum erosion–corrosion and erosion rates occurred at impingement angles of about 25...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Tribol. July 2015, 137(3): 031604.
Paper No: TRIB-14-1186
Published Online: July 1, 2015
...: Robert Wood. 26 07 2014 21 02 2015 08 04 2015 Erosion, erosion–corrosion, and synergistic behaviors of AISI 420 stainless steel were studied in 3.5 wt.% NaCl solution containing silica sand with the size of 250–500  μ m as erodent particle. The erosion and erosion–corrosion...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Tribol. July 2015, 137(3): 031105.
Paper No: TRIB-14-1114
Published Online: July 1, 2015
.... , and Abdulrahman , G. , 2010 , “ Mapping Erosion–Corrosion of Carbon Steel in Oil Exploration Conditions: Some New Approaches to Characterizing Mechanisms and Synergies ,” Tribol. Int. , 43 ( 7 ), pp. 1268 – 1277 . 10.1016/j.triboint.2010.01.005 [3] Li , Y. , Burstein , G. T. , and Hutchings...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Tribol. April 2015, 137(2): 021602.
Paper No: TRIB-14-1151
Published Online: April 1, 2015
...: Robert Wood. 05 07 2014 28 10 2014 12 12 2014 This paper explores new approaches in design and fabrication of novel composite materials in order to increase corrosion and wear resistance. By mimicking nature, nacreous particles from seashells were used as reinforcement...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Tribol. April 2014, 136(2): 021102.
Paper No: TRIB-13-1217
Published Online: January 20, 2014
.... Nikas. 14 10 2013 13 12 2013 The formation of a ring area around the cavitation erosion pit on carbon steel is due to the cavitation erosion–corrosion. For the ultrasonic irradiation in water, both the ultrasonic cavitation and the acoustic streaming are generated. Due...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Tribol. April 2007, 129(2): 419–423.
Published Online: August 4, 2006
...N. H. Jayadas; K. Prabhakaran Nair In this paper, the corrosion properties of vegetable oils as base oil for industrial lubricants are evaluated by the copper strip corrosion test (ASTM D130) and rust prevention test (ASTM D665). An analysis of possible organic reaction mechanisms leading...